![]() ![]() Then I placed the measuring piece on top, carefully predrilled a hole and then drove in my 1 1/4″ screw. First I applied my wood glue and a couple of drops of CA glue to the bottom of the slider. Next glue and screw your measuring piece onto the slider. Mix your Epoxy and Epoxy the nut into the hole.ħ. Then I drilled a hole in the center of this hole, the same size as my bolt all the way through the slider. I drilled a 3/8″ hole the depth of the nut into the top of my slider. If your slot isn’t perfectly in line with the rabbet you may want to line it up in the slot while you mark your hole, jut to be sure it ends up on the top of your slider. Also make sure you put the hole at the top of the slider. I put the hole where my knob screwed in the top edge of the slider. Make sure you can fully turn your knob with the measuring piece also in place. ![]() Make sure you line these pieces up as the would sit in the slot while you glue them, just in case your slot isn’t perfectly in the center of the rabbet.įigure out where you’re going to place your knob. I also used a couple of drops of CA glue, so that it would set faster. Next, glue the 1/2″ wide piece to the piece that fits in the T slot with wood glue. Mix your 2 part Epoxy and epoxy the bolt head into the knob. Just make sure that you don’t drill it too deep, because you need the bolt to go all the way through the sliding piece and slightly dig into the wood. I drilled my hole about half the depth of the rainbow. I drilled my hole using a 3/8″ forstner bit on the drill press. ![]() That would be the highest point for the curve.ĭrill a hole in the back of the knob close to the side of your bolt head. I measured 80″ from the bottom of the board. I used an old light, but I think a bucket, pot, or lid would also work for this. First find a rounded edge to trace a curved edge. This step is optional, but I think it added a nice touch to the growth chart. Step by Step Tutorial Step 1 Round off the top of the board
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |